85mm Classical Tachometer 0-10000RPM Tacho Gauge With LCD Hourmeter For Car Boat

Description: 85mm Classical Tachometer 0-10000RPM Tacho Gauge With LCD Hourmeter For Car Boat85mm Classical Tachometer Gauge 0-10000RPM LCD Display Engine Working Hours 0-99999.9H With Backlight Features: -Be suitable for motorcycle marine boats,truck, excavator, tractor ect.-Tachometer using stepper motor drive pointer, accurate display of the engine RPM, and with the LCD display clear display hour. - The LCD display clear display hour, with instructions of high precision, repeatability and versatility, reliability and stability, drive And control is relatively simple and so on.-316 Stainless steel bezel with curved glass.-Convenient Installation by multi-plug socket connecting way.-Total Hourmeter can be adjusteed-Overspeed buzzer alarm threshold value can be adjusted. Technical Data: Name: TachometerMaterials: stainless steel+nickel-plated plasticOperating Voltage: 12V/24VIndicating Range: 0-10000RPMInput Signal: Pulse Signal from engine speed sensor, engine, alternator, ignition coil, crankshaft sensor, etc.Adjustable speed ratio: 0.5-250.0Protection Class: IP67, can work underwater 1 meter position Function Select (Pulse, Hour, Buzz) Press and hold on the button at the back, then turn on the power supply. The LCD will show PULSE, HOUR, BUZZ, etc. You can select the function to be set after release button.1.“PULSE” (change RPM Ratio) After selecting “PULSE”, the LCD will show for example “P 3” (3 means 3pulses per round) after 3 seconds. Press the button to change the flashing digit in the LCDYou can select “PULSE” again to confirm the setting is done. How to confirm RPM Ratio? a. If your sensor is installed on the flying wheel panel, the RPM ratio is equal to the number of gears of the engine. b. If the speed signal takes from W-Terminal, the RPM ratio is equal to the half of the number of poles.2.“HOUR”(change total hour meter) After selecting “HOUR”, the LCD will show for example “5000” (5000 HOUR) , press the button to change the flashing digit from 0 to 99999 to set the target value.3.“BUZZ”(change overspeed buzzer alarm threshold value) After selecting “BUZZ”, the LCD will show for example “B 3000” (buzzer will be on when speed over 3000RPM), press the button to change the flashing digit from 0 to 8000 to set target overs RPM buzzer alarm threshold value. Please noted: After setting, you should disconnect both Power+ and GND, and then reconnect the two cable, then it will save the setting. If you just cut Power +, then it’ll not work properly. Package Includes: 1x Tachometer1x Multi-plug socket1x Installation Instruction

Price: 59.96 AUD

Location: GZ

End Time: 2024-09-12T08:09:50.000Z

Shipping Cost: 0 AUD